Quality Gear - Dana 50 Differential

Dana 50 Differential

The Dana/Spicer Model 50 is an automotive axle used solely in OEM Ford applications. Dana 50's were made as front axles only. The Dana 50 has a "50" cast in to the housing and is regarded as having more strength than a Dana 44, but not as much as a Dana 60. It was only produced in a reverse cut gear set (high pinion).

The Dana 50 was made as a solid axle and as a Twin Traction Beam (TTB) which pivots in the center allowing the wheels to move independent of each other. A unique quality of the Dana 50 axle is the lack of variation in both TTB and Solid axle versions, which simplifies repairs and upgrades. There were no carrier breaks and only one spline count (30 spline). Gross axle weight ratings were lowered by Ford for safety and tire reasons.

Dana Differential parts available include:
Axle Shafts, Cases, Limited Slips, Lockers, Nest Kits, Rebuild Kits, Rings & Pinions

    Dana 50 Specs
  • Ring gear measures 9.0".
  • 30 Spline Axle shafts.
  • Gear Ratios: 3.55:1 - 5.38:1
  • No carrier breaks
  • Pinion shaft diameter: 1.375"
  • Pinion shaft splines: 26
  • Axle shaft diameter: 1.21"
  • Axle spline diameter: 1.31"

Other Information:

Twin Traction Beam

The Twin Traction Beam or TTB was used in the Ford F-250 from 1980 to 1997. The TTB Dana 50 was also used selectively in the F-350 from 1980 to 1986. The GVW was lower in a F-350 with a TTB Dana 50, than a F-350 with a solid axle. The gross axle weight rating of a TTB Dana 50 was 4600 lbs.

  • The Dana 50 TTB spindles will accept the Dana 60 hubs however the knuckles ARE NOT interchangable.
  • All Dana 50 TTB axles were leaf sprung axles.

Solid Axle

The solid axle Dana 50 was used in the Ford F-250 and selectively in the F-350 from 1998 to 2004. This axle was also the only OEM axle used in Four-wheel drive Ford Excursions. The gross axle weight rating of a solid axle Dana 50 is 5000 lbs.

    Compatible with Models

    Ford

A Genuine Quality Gear Upgrade

Parts listed are not necessarily manufactured by the original equipment manufacturer and any reference to the trademarks or part numbers of others are for cross reference informational purposes only.